Material: PVC Processing custom: as shown in figure Strong adhesion: Applicable places: body Design: totem series PVC material quality assurance 2 years do not fade not degum will not hurt the car paint Replace a trace is not reflective 2.8 m side, both sides is a body full ~! A complete set of is: the body to stick a fire bar Installation method: A small car with a transparent transfer film. The installation method (dry paste method): 1, clean body, keep dry. 2, to determine a good place to. In general, the side of the stick slowly, while whiletoolsevenness, while Jiedi paper. 3, if the graph is really small, but also the transparent film and stickers all tear paste. But be careful not to accidental adhesion. 4, good paste, and then repeated several times blowing pressure. Tear apart the transparent film. 5, on the door and sewn with a knife knife, Fu fold inward. 6, don't let the car body and any separation or protuberance. Two. A large car with a transparent transfer film installation method (wet sticking method): Tools: cloth, watering utensil, scraper or credit card 1, clean body, sprinkle water to reduce viscosity, easy to adjust position in the sticker will be posted on the body. 2, to determine a good place to. The side of the stick slowly, while gently whiletoolsevenness, while Jiedi paper. 3, meet the door handle or rubbing strips according to the material and cut into. 4, appropriate adjustments will determine the correct location of graphics, forced repeated scrape and bubble water. Tear apart the transparent film. 5, on the door and sewn with a knife knife, obedient fold inward. 6, don't let the car body and any separation or protuberance. 7, try to let the car in the water dry conditions can moderate heating and drying. According to the weather condition, one or two days after washing. For customers to reduce the installation difficulty, we provide the stickers beforehand good transfer film. (except the whole continuous graphic) How to remove: Gently blowing nail stickers edge, then the tear, will not leave marks will not damage the car paint. If it is cold in winter to sweep the corner, hair dryer available to appropriate heating tape, glue can be easily removed after the soft thaw. Note: 1, in deciding to dress up the car before a week not waxing, wax will make stickers glue rickety; stickers pasted after three days do not wash the car, don't stick in the rainy days, so the effect will be bad Oh! 2, such as stickers affixed to the door or other activities, don't worry, good paste can be cut with a sharp knife. 3, if they don't want to do, go to a local place to ask for help to stick solar film.